Okay, cool. Here's the breakdown...
I use RSI(EMA) and DMI (directional movement index) exclusively.
for USD/JPY: RSI(10) and DMI(7). I get a pre-buy signal when RSI goes below 30 at the same time that DMI is above 30, then buy when RSI crosses back over 30. I get a pre-sell when RSI goes above 85 while DMI is above 30, then sell when RSI crosses below 70. And to note, I only take a signal as valid if the candle has closed.
for EUR/JPY: exactly the same as for USD/JPY
for GBP/USD: RSI(8) and DMI(6). I use the same DMI>30 "confirmation" and RSI cross-overs. Except RSI has to go below 20 for a buy signal now, and RSI only has to go over 80 for a sell signal. As you can see, there is no buy/sell bias (which there is for EUR/JPY and USD/JPY), and the indications are essentially mirrored for buy and sell.
for EUR/USD: exactly the same as GBP/USD
I think this is a little out of the ordinary, since I'm basically using RSI as an oscillator. I know these both measure trend strength, but what I've noticed, if you separate the values a little, the RSI can shoot above 80 while the DMI is still below 30, then fall down again, which helps me avoid fakeouts. When they allign, I know there is a very strong trend, and then I start looking for the retrace. When RSI crosses back over the 30/70 level, I can generally expect the retrace to continue to the retracement level I pick, 0.618 for instance. I think 70 is a good balance between getting a reliable signal and getting a signal early enough to profit from it.
Different pairs retrace differently, depending on the buy/sell signal too, which is why each has its own tailored retracement level. Overall, I'm banking on the idea that if something rises/falls too fast, too much, there has to be some form of retracement, and if you know when to catch it, you're gonna make money! Good luck, and of course this is open to any kind of critique and comments
