For those of you looking at what a 2 bar reversal should look like I have an example that Johnathon has highlighted. Not sure if he has posted it on this forum.
Remember like all PA we are looking to trade them from swing points (it is number 2 in the 1-2-3 sequence) and both bars, wicks included, should be the same approximate size. It is not just enough to have a bull bar followed by a bear bar.
To be honest I don’t pay much attention to channels. I am looking at horizontal Support and Resistance as the levels from which I play my trades off.
Who knows what will happen in this particular trade. I am looking to move to BE due to the short term support I can see to my left but to be honest no I don’t pay any attention to channels or even too much attention to trend lines, but each to their own.
Bhops, if you don’t mind comparing target areas, my initial target is 1.037. Will look to move to break even at that area with remaining targets: T2 - 1.034 and T3 - 1.031.
Not really from a swing low, a tiny bar when compared to it’s immediate predecessors and against short term momentum. What’s not to like? :eek: Just kidding Dudest, but really not for me.
No worries mate, I’ve been following this thread for a while now and I can see how you, spongybob and Bhops have been trading well implementing Jonathan’s method. Good job guys!